What instructions have you followed thus far?
Here's the definitive page (all others should be considered obsolete or
questionable at best):
http://www.nslu2-linux.org/wiki/SlugO/InstallandTurnupABasicSlugOSSystem
As noted by Patrick already, SlugOS has neither a telnet server nor a
web server installed -- SSH is the only way to communicate with SlugOS,
at least until you get some external storage configured and install
either a web server or a telnet server.
-Mike (mwester)
On 11/2/2012 11:33 AM, underscoretom wrote:
> I recently purchased a used NSLU2 with the intent of putting wview on it for weather station support.
>
> Upon installing the latest SlugOS per instructions, I cannot access the slug in any way (telnet or via the web interface, nor any ping) once the installation is complete and it reboots. Reading around suggested I should install unslung OS first and confirm the IP address is set to what I expect it to be. Installing unslung works fine. I can install (including SSH) and configure as its instructions suggest. But then when installing SlugOS again, same response. I am not able to telnet or use the web interface (*.77 default).
>
> Suggestions?
>
>
>
> ------------------------------------
>
> Yahoo! Groups Links
>
>
>
>
>
| Reply via web post | Reply to sender | Reply to group | Start a New Topic | Messages in this topic (3) |
No comments:
Post a Comment