I recently purchased a used NSLU2 with the intent of putting wview on it for weather station support.
Upon installing the latest SlugOS per instructions, I cannot access the slug in any way (telnet or via the web interface, nor any ping) once the installation is complete and it reboots. Reading around suggested I should install unslung OS first and confirm the IP address is set to what I expect it to be. Installing unslung works fine. I can install (including SSH) and configure as its instructions suggest. But then when installing SlugOS again, same response. I am not able to telnet or use the web interface (*.77 default).
Suggestions?
__._,_.___
Reply via web post | Reply to sender | Reply to group | Start a New Topic | Messages in this topic (1) |
.
__,_._,___
No comments:
Post a Comment