Craig,
Thank you for your "--enable-libusb01_build" tip, it does configure with libusb01 fine, no need for libusb1 here. However, your makefile is missing some important stuff. The reason I do so much patching after running configure script is to make sure that instead of standard "/usr", "/etc", "/var" locations all settings and files are installed and later at run time properly addressed to under "/opt". I grepped through python scripts, c++/c sources and Makefile to find which files need to be patched for this, and how. I'm guessing that network backend issue Peter had may be related to patching Makefile.am only and then reconfiguring.
According to config.log, net-snmp is properly recognized as usable by the configure script. My best guess about Peter's problems is, however vague it is, that something is just looking for something else in a wrong place.
And no, I haven't acquired a developer certificate yet
2013/12/30 Craig Noble <ipsen200@yahoo.com>
Alex,Peter tried my hplip package earlier and reported an issue with the network backend. Can you confirm that your build has configured with "--enable-network-build", it should be default, but if it can't find net-snmp in the staging dir then it'll silently drop it from the build.
Add net-snmp to the depends and net-snmp-stage to the configure section to make sure it'll build cleanly from scratch.
Cheers,
Craig.
On Sunday, December 29, 2013 5:32 PM, Alex Potapenko <opotapenko@gmail.com> wrote:
Hello Paul,Sorry for the sane-related comments. I used libusb.mk as a basis for writing libusb1.mk, and replaced the header comments containing libusb package versions history with the usual stuff, like the one in template.mk. Took it from sane-backends.mk, since I was upgrading it to v1.0.24 a little earlier. Just forgot to replace all occurrencesPeter,I've built hplip-3.13.11 and libusb-1.0.9 for cs08q1armel target. You can give them a go if you want to:Hope it works
Best regards,
Alex Potapenko
__._,_.___
| Reply via web post | Reply to sender | Reply to group | Start a New Topic | Messages in this topic (10) |
.
__,_._,___
No comments:
Post a Comment