Can you confirm that you are getting the slug into upgrade mode? If it is not in that mode, upslug2 will never see it. You hold the reset button in while turning it on and after about 10-15seconds, the top LED starts blinking between red and green. You must release the reset button immediately upon seeing the first LED change.
I use upslug2 exclusively and it works very well so that is one variable removed.
Steve
On 10-12-19 3:38 AM, tonjg wrote:
as an update I'm still having this problem and there are some things I've
tried but not worked.
1) I booted the slug and watched the traffic its trafic in wireshark. Each
time it boots it sends out three dhcp discovery pings (then the device beeps
3 times) but it never picks up an address. Other devices connected to my
router have no problem picking up an address. This slug worked perfectly on
the network before the flash upgrade.
2) I tried the 'all upgrade utility' thing but it caused havoc on three out
of four windows pc's and when it did finally run it couldn't find the slug.
3) I then tried upslug2 from a linux pc but that can't find the slug either.
I'm running out of ideas so any help appreciated.
--
View this message in context: http://old.nabble.com/newbie%3A-firmware-flash-now-cannot-access-slug-tp30491664p30491871.html
Sent from the Nslu2 - Linux mailing list archive at Nabble.com.
No comments:
Post a Comment