Good afternoon
Do Jan 02 16:51:41 2014
Thank You for email and help.
Am 23.12.2013 22:58, schrieb Cameron Simpson:> On 20Dec2013 23:41,
trevor pearson <trev15evil@yahoo.co.uk> wrote:
> > On 20/12/13 18:13, highskywhy@yahoo.de wrote:
> > > How to control traffic in Linux?
> > > zip is very unimportant and should work very slow
> > > how can I start zip and zip should use only a small part of the cpu
> >
> > nohup nice -n 15 zip command that is long >/dev/null >>/dev/null &
> >
> > If output/error messages are important (or you want to check them)
> >
> > nohup nice -n 15 zip-command-to -do >~/zip.log >~/zip.error &
> >
> > the 15 can be any number from 11 (slightly less important) to 20 (Only
> > when there is nothing else to do) 20 will run very slowly!
>
> Notes:
>
> 1: The default nice value is 10.
> For most low priority programs you can just use "nice".
> Eg:
>
> nice unzip ....
*
It is enough
nice unzip
and unzip is very slow.
?
And what is the opposite
zip should be very very fast and important?
>
> No tedious -n required. Just ask the command to be "nice".
>
> 2: trevor is missing some redirection stuff:
> The standard incantation is:
>
> >filename 2>filename-for-errors
>
> If those are the same file, then:
>
> >filename 2>&1
>
> The order matters, too. This is applied left to right.
>
> 3: Nohup, if run on a terminal, automatically redirects out put to
> the file "nohup.out". If that is enough, you don't need any
> redirections at all.
> Eg:
*
OK
>
> nohup nice unzip ...
>
> 4: Perhaps not made clear: nice affect the _share_ of CPU your
command gets.
> If you system is otherwise idle, a nice program can use the whole CPU.
> If the system is busy, the nice programs get a smaller share than other
> programs.
OK
>
> Simpler and easier.
>
> Perhaps
>
> Cheers,
> --
Thank You
Regards
Sophie
| Reply via web post | Reply to sender | Reply to group | Start a New Topic | Messages in this topic (6) |
No comments:
Post a Comment