THIS is or react Internet Link, for SlugOS.
Earlier link had a typo.
http://www.nslu2-linux.org/wiki/SlugOS/InstallandTurnupABasicSlugOSSystem
--- In nslu2-linux@yahoogroups.com, "Mike Westerhof (mwester)" <mwester@...> wrote:
>
> What instructions have you followed thus far?
>
> Here's the definitive page (all others should be considered obsolete or
> questionable at best):
>
> http://www.nslu2-linux.org/wiki/SlugO/InstallandTurnupABasicSlugOSSystem
>
> As noted by Patrick already, SlugOS has neither a telnet server nor a
> web server installed -- SSH is the only way to communicate with SlugOS,
> at least until you get some external storage configured and install
> either a web server or a telnet server.
>
> -Mike (mwester)
>
>
>
> On 11/2/2012 11:33 AM, underscoretom wrote:
> > I recently purchased a used NSLU2 with the intent of putting wview on it for weather station support.
> >
> > Upon installing the latest SlugOS per instructions, I cannot access the slug in any way (telnet or via the web interface, nor any ping) once the installation is complete and it reboots. Reading around suggested I should install unslung OS first and confirm the IP address is set to what I expect it to be. Installing unslung works fine. I can install (including SSH) and configure as its instructions suggest. But then when installing SlugOS again, same response. I am not able to telnet or use the web interface (*.77 default).
> >
> > Suggestions?
> >
> >
> >
> > ------------------------------------
> >
> > Yahoo! Groups Links
> >
> >
> >
> >
> >
>
| Reply via web post | Reply to sender | Reply to group | Start a New Topic | Messages in this topic (6) |
No comments:
Post a Comment