Saturday, November 3, 2012

Re: [nslu2-linux] Unable to access slug after installing SlugOS

 

I did pretty much everything on the page, except the Optware stuff at the bottom. I then installed lighttpd, perl, and rsync. When launching lighttpd, it will give erros about missing libraries. Just use the 'opkg install ???" where ? marked is replaced by the name of the missing library. Just use the name and not the version part. Let us know how you are doing and we can get you running out there.

Patrick



On Sat, Nov 3, 2012 at 10:34 AM, Mike Westerhof (mwester) <mwester@dls.net> wrote:
 

What instructions have you followed thus far?

Here's the definitive page (all others should be considered obsolete or
questionable at best):

http://www.nslu2-linux.org/wiki/SlugO/InstallandTurnupABasicSlugOSSystem

As noted by Patrick already, SlugOS has neither a telnet server nor a
web server installed -- SSH is the only way to communicate with SlugOS,
at least until you get some external storage configured and install
either a web server or a telnet server.

-Mike (mwester)



On 11/2/2012 11:33 AM, underscoretom wrote:
> I recently purchased a used NSLU2 with the intent of putting wview on it for weather station support.
>
> Upon installing the latest SlugOS per instructions, I cannot access the slug in any way (telnet or via the web interface, nor any ping) once the installation is complete and it reboots. Reading around suggested I should install unslung OS first and confirm the IP address is set to what I expect it to be. Installing unslung works fine. I can install (including SSH) and configure as its instructions suggest. But then when installing SlugOS again, same response. I am not able to telnet or use the web interface (*.77 default).
>
> Suggestions?
>
>
>
> ------------------------------------
>
> Yahoo! Groups Links
>
>
>
>
>



__._,_.___
Reply via web post Reply to sender Reply to group Start a New Topic Messages in this topic (4)
Recent Activity:
.

__,_._,___

No comments:

Post a Comment