Hi Alessandro,
I hope you can use 'Google Translation' to understand what I write here:
Before you can unsling the operating system into a USB drive, you must format it using the GUI of the NSLU2. Go to the IP address, port 8080 and use the Administration to format the disk. When it completes formating the disk, you should click on Telnet in the menu of the GUI and be able then to run telnet in a terminal to connect to your NSLU2.
Then run: unsling diskX
where X=1 or 2, depending which disk you were formating.
If this was a sudden failure (like mine has been) then it is quite likely that your power supply is faulty and you should replace it, just as I am about to do. :-)
Hope this helps.
__._,_.___
Posted by: mick_nslu2@yahoo.com
| Reply via web post | • | Reply to sender | • | Reply to group | • | Start a New Topic | • | Messages in this topic (2) |
.
__,_._,___
No comments:
Post a Comment