On 02/03/13 03:02, Donald wrote:
>
>
> I am running a Cisco Lynksys E1200 router. I would like to know if there
> is any Linux command that will reveal the what ports are open in the
> router. I know that the ifconfig will give up the IP and Bcast and Mask
> info. Yes I am new to Linux...learning just a little bit at a time!
> Thank you
> 73
> VE3HOL
There is a utility called nmap, it can be run froma connected machine to
scan the router, try nmap -sT this will show open
ports on the router from your p.c. 's side .
Trev
__._,_.___
| Reply via web post | Reply to sender | Reply to group | Start a New Topic | Messages in this topic (2) |
To unsubscribe from this list, please email LINUX_Newbies-unsubscribe@yahoogroups.com & you will be removed.
.
__,_._,___
No comments:
Post a Comment