Tuesday, December 21, 2010

Re: [nslu2-linux] newbie: firmware flash now cannot access slug

 

For the record, I think the wiki has a reasonable explanation about the LED colors when going into upgrade mode.

http://www.nslu2-linux.org/wiki/SlugOS/UsingTheBinary

If you wish to clarify it please do. I have early units and you have later units. The bit about the network connection is definitely new to me (my early units don't care if the network cable is connected or not) and it would be good to add it to the wiki.

Steve


On 10-12-21 12:50 PM, tonjg wrote:

 



sdm485 wrote:
>
> Curious about the reset into upgrade not working;

if it benefits anyone else, this is what happens with my slug. The stuff on
the wiki about a red flashing light is baloney. I get an orange light, and
then after about ten seconds I get a tiny tiny variation on the orange. The
light goes slightly dimmer and thats when I release the reset button and
that's when the upgrade mode works. But the difference between the two is
really really hard to spot, and it only works if there is no network cable
connected.

--
View this message in context: http://old.nabble.com/newbie%3A-firmware-flash-now-cannot-access-slug-tp30491664p30509155.html
Sent from the Nslu2 - Linux mailing list archive at Nabble.com.


__._,_.___
Recent Activity:
MARKETPLACE

Hobbies & Activities Zone: Find others who share your passions! Explore new interests.


Get great advice about dogs and cats. Visit the Dog & Cat Answers Center.


Stay on top of your group activity without leaving the page you're on - Get the Yahoo! Toolbar now.

.

__,_._,___

No comments:

Post a Comment