sdm485 wrote:
>
> Can you confirm that you are getting the slug into upgrade mode? If it
> is not in that mode, upslug2 will never see it. You hold the reset
> button in while turning it on and after about 10-15seconds, the top LED
> starts blinking between red and green. You must release the reset button
> immediately upon seeing the first LED change.
yes I've read and re-read the upgrade article and tried the upgrade many
times but my slug will not do what its supposed to. During the boot,
regardless of whether the reset button is pressed in or not I never get the
top led blinking red and green. Never. The only lights I get are either
blinking orange or blinking green. Pressing the reset button in makes no
difference to the startup sequence of the slug. Here is a little video of
the boot sequence. (5Mb)
http://www.zen187664.zen.co.uk/linksys/slugbootup.avi
--
View this message in context: http://old.nabble.com/newbie%3A-firmware-flash-now-cannot-access-slug-tp30491664p30494174.html
Sent from the Nslu2 - Linux mailing list archive at Nabble.com.
No comments:
Post a Comment